LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2741 (Engine Controls - Pinpoint Test Hg: Positive Crankcase Ventilation (PCV) System Through Pinpoint Test JD: Crankshaft Position (CKP) Sensor - (Except Diesel & Hybrid)) >> PINPOINT TEST JB: Secondary Ignition (COP) >> Introduction

PINPOINT TEST JB: Secondary Ignition (COP): Introduction

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: A malfunctioning ignition system may cause high catalyst temperatures. Check the components next to the catalyst and muffler for heat damage.

This pinpoint test is intended to diagnose the following:

Fig 1: Coil On Plug (COP) Connector - A
GF0001513Courtesy of FORD MOTOR CO.
Fig 2: Coil On Plug (COP) Connector - B
GF0001559Courtesy of FORD MOTOR CO.
Vehicle Connector Pin Circuit
Edge,
MKX,
MKZ
A 2 IGN START/RUN
Escape,
Five Hundred,
Focus,
Freestyle,
Fusion,
Mariner,
Milan,
Montego
B 2 IGN START/RUN
All other vehicles B 1 IGN START/RUN
Vehicle Firing Order for Coil On Plug Applications
BASE, 4-cylinder applications 1 3 4 2
BASE, 6-cylinder applications 1 4 2 5 3 6
BASE, 8-cylinder applications 1 3 7 2 6 5 4 8
BASE, 10-cylinder applications 1 6 5 10 2 7 3 8 4 9