LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2719 (Interior Trim & Ornamentation) >> Removal And Installation >> Scuff Plate Trim Panel - Front, Lighted Outer >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The front lighter outer scuff plate is only available on the MKZ.
  1. Remove the front door scuff plate. For additional information, refer to SCUFF PLATE TRIM PANEL - FRONT  in this service information.
  2. Remove the B-pillar lower trim panel. For additional information, refer to B-PILLAR TRIM PANEL  in this service information.
  3. Disconnect the scuff plate trim panel electrical connector located behind the lower B-pillar trim panel.
    4. NOTE: To avoid damage to the scuff plate trim panel, remove any retaining clips from the body and attach them to the scuff plate trim panel before installing.
  4. Remove the front, lighted outer scuff plate trim panel by lifting straight up and releasing the 2 retaining clips from the body.
  5. To install, reverse the removal procedure.
    • Align the retaining clips to the body and snap in place.
scientia non olet · About LEMON Manuals