Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- Remove the liftgate trim panel. For additional information, refer to
EXTERIOR TRIM & ORNAMENTATION -- FUSION, MILAN & MKZ
article.
- Position the water shield aside.
Fusion
- Remove the luggage compartment lid panel applique. For additional information, refer to
EXTERIOR TRIM & ORNAMENTATION -- FUSION, MILAN & MKZ
article.
- Disconnect the electrical connector.
- Remove the 2 screws and the video camera and bracket assembly.
Milan
- Remove the high mounted stoplamp. For additional information, refer to
EXTERIOR LIGHTING -- FUSION, MILAN & MKZ
article.
- Disconnect the electrical connector.
- Remove the 2 screws and the video camera and bracket assembly.
MKZ
- Remove the video camera by prying on the two outer retaining tabs with a suitable tool, such as a flat bladed screwdriver.
- Disconnect the electrical connector.
All vehicles
- To install, reverse the removal procedure.