LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Activating System >> Diagnostics Activating Procedure (Driver- & Passenger-side AIR Bags)

Diagnostics Activating Procedure (Driver- & Passenger-side AIR Bags)

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy. Remove air bag simulator from clockspring connector. Install driver-side air bag module. Remove air bag simulator from passenger-side air bag vehicle harness connector. Install passenger-side air bag module.
  2. Reconnect negative battery cable. Perform system operation check. See SYSTEM OPERATION CHECK  . Perform computer relearn procedure. See COMPUTER RELEARN  . Reprogram pre-set radio frequencies and set clock.
scientia non olet · About LEMON Manuals