Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The sport metallic accelerator pedal pad is not to be re-used. If the sport metallic accelerator pedal pad is removed it should be discarded and replaced with a new sport metallic accelerator pedal pad.
- Disconnect the accelerator pedal sensor electrical connector.
- Remove the 2 nuts and the accelerator pedal and sensor assembly.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.