Clutch Master Cylinder: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Install the clutch master cylinder assembly.
Install the clutch master cylinder nut.
- Tighten to 21 Nm (15 lb-ft).
  
  Fig 1: Locating Clutch Master Cylinder Nut
  Courtesy of FORD MOTOR CO.
Working under the instrument panel, install the clutch master cylinder nut.
- Tighten to 21 Nm (15 lb-ft).
  
  Fig 2: Locating Clutch Master Cylinder Nut
  Courtesy of FORD MOTOR CO.
Connect the clutch master cylinder reservoir hose.

Fig 3: Locating Clutch Master Cylinder Reservoir Hose
Courtesy of FORD MOTOR CO.
Connect the clutch master cylinder-to-clutch hydraulic tube.
- Tighten the clutch hydraulic tube nut to 17 Nm (150 lb-in).
  
  Fig 4: Locating Clutch Master Cylinder-To-Clutch Hydraulic Tube
  Courtesy of FORD MOTOR CO.
Install the PCM bracket and 3 PCM bracket nuts.
- Tighten to 10 Nm (89 lb-in).
  
  Fig 5: Locating PCM Bracket Nuts And PCM Bracket
  Courtesy of FORD MOTOR CO.
Install the PCM.
1. Install the 2 PCM bolts.
  - Tighten to 10 Nm (89 lb-in).
2. Connect the electrical connectors.
  
  Fig 6: Identifying PCM Electrical Connectors And PCM Mounting Bolts
  Courtesy of FORD MOTOR CO.
Install the battery tray. For additional information, refer to BATTERY, MOUNTING & CABLES -- FUSION, MILAN & MKZ article.
Bleed the clutch hydraulic system. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION & CLUTCH - GENERAL INFORMATION - FUSION & MKZ article.