LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2679 (Automatic Transaxle External Controls (Hybrid)) >> Diagnosis And Testing >> External Controls >> Symptom Table - NVH

Symptom Table - NVH

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: NVH symptoms should be identified using the diagnostic tools that are available. For a list of these tools, an explanation of their uses and a glossary of common terms, refer to NOISE, VIBRATION & HARSHNESS article. Since it is possible any one of multiple systems may be the cause of a symptom, it may be necessary to use a process of elimination type of diagnostic approach to pinpoint the responsible system. If this is not the causal system for the symptom, refer back to NOISE, VIBRATION & HARSHNESS article for the next likely system and continue diagnosis.
SYMPTOM TABLE - NVH

Condition Possible Sources Action
  • Vibration - a high frequency (20-80 Hz) vibration that is felt through the seat or the selector lever. Changes with engine speed
  • Selector lever cable incorrectly routed, grounded out or loose
  • Loose selector lever cable bracket
  • CHECK the selector lever cable and bracket for damage and correct assembly. REFER to SELECTOR LEVER CABLE  in this service information. REPAIR as necessary.
  • Rattle, noise, buzz or other noise
  • Selector lever loose
  • Noisy selector lever
  • TIGHTEN the selector lever nuts.
  • INSTALL a new selector lever. REFER to the SELECTOR LEVER  in this service information.