Selector Lever Cable: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the heater core and evaporator core housing. For additional information, refer to CLIMATE CONTROL -- FUSION, MILAN & MKZ article.
Remove the Restraints Control Module (RCM). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM -- FUSION, MILAN & MKZ article.
Remove the battery tray. For additional information, refer to BATTERY, MOUNTING & CABLES -- FUSION, MILAN & MKZ article.

NOTE: Aisin AW21 shown in the illustration, 6F35 similar.

Fig 1: Locating Selector Lever Cable End

Courtesy of FORD MOTOR CO.

Disconnect the selector lever cable end from the manual control lever.

NOTE: Aisin AW21 shown in the illustration, 6F35 similar.

Fig 2: Locating Selector Lever Cable Tabs

Courtesy of FORD MOTOR CO.

Release the 2 tabs and remove the selector lever cable from the selector lever cable bracket.
Disconnect the 2 wiring harness fasteners and position the RCM wiring harness aside.

Fig 3: Locating RCM Wiring Harness Fasteners
Courtesy of FORD MOTOR CO.
Position the insulation blanket away from the bulkhead to gain access to the 2 selector lever cable bracket nuts.

Fig 4: Locating Insulation Blanket
Courtesy of FORD MOTOR CO.
Remove the 2 selector lever cable grommet nuts and remove the selector lever cable through the interior of the vehicle.

Fig 5: Locating Selector Lever Cable Grommet Nuts
Courtesy of FORD MOTOR CO.