LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2678 (Automatic Transaxle External Controls - AISIN Aw21/6F35 (Except Hybrid)) >> Diagnosis And Testing >> External Controls >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern by operating the system.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
  3. If an obvious cause for an observed or reported concern is found, correct the cause before proceeding to the next step.
  4. If the concern is not visually evident, verify the symptom. GO to SYMPTOM TABLE - EXTERNAL CONTROLS  or GO to SYMPTOM TABLE - NVH .
VISUAL INSPECTION

Mechanical Electrical
  • Transmission selector lever cable
  • Manual control lever
  • Selector lever or selector lever knob
  • Smart Junction Box (SJB) fuse 5 (10A)
  • Battery Junction Box (BJB) fuse 47 (10A)
  • Connections
  • Wiring harness
  • Brake Pedal Position (BPP) switch
  • Brake Shift Interlock Actuator (BSIA)
  • SelectShift™ switch
  • Transmission Control Switch (TCS) (vehicles equipped with a 2.5L engine)
DIAGNOSTIC TROUBLE CODE TABLE

DTC Component Description Condition Symptom Action
B2572 Brake Shift Interlock Brake Shift
Interlock Output
Circuit Failure		 The associated circuitry connected to the Smart Junction Box (SJB) or fuse, or the SJB itself may have an issue causing a brake shift interlock concern. Brake shift interlock is inoperative or does not operate correctly. GO to PINPOINT TEST A .
P0815 SelectShift™ Switch SelectShift™
Switch Output
Circuit Failure		 The associated circuitry connected to the SelectShift™ switch or fuse, or the SelectShift™ switch itself may have an issue causing a fault. SelectShift™ operation is inoperative or does not operate correctly. GO to PINPOINT TEST C .
P0816 SelectShift™ Switch SelectShift™
Switch Output
Circuit Failure		 The associated circuitry connected to the SelectShift™ switch or fuse, or the SelectShift™ switch itself may have an issue causing a fault. SelectShift™ operation is inoperative or does not operate correctly. GO to PINPOINT TEST C .
P0819 SelectShift™ Switch Up And Down Shift
Switch To
Transmission
Range (TR)
Correlation		 The associated circuitry connected to the SelectShift™ switch or fuse, or the SelectShift™ switch itself may have an issue causing a fault. SelectShift™ operation is inoperative or does not operate correctly. GO to PINPOINT TEST D .
scientia non olet · About LEMON Manuals