LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2677 (Electronic Engine Controls - 3.5L) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the LH catalytic converter. For additional information, refer to EXHAUST SYSTEM -- FUSION, MILAN & MKZ article.
  3. Remove the bolt, nut and the heat shield.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the rubber grommet cover.
  5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
  6. Remove the bolt and the CKP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  7. To install, reverse the removal procedure.
  8. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals