LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2677 (Electronic Engine Controls - 3.5L) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - 3.5L -- FUSION & MKZ article.
  2. Disconnect the Camshaft Position (CMP) sensor electrical connector.
  3. Remove the bolt and the CMP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    4. NOTE: Lubricate the CMP sensor O-ring seal with clean engine oil.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals