Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS -- FUSION, MILAN & MKZ article.
- Disconnect the windshield washer pump electrical connector.
- Disconnect the washer pump hose.
Hybrid vehicles
- Remove the coolant reservoir bolt and nut and position the reservoir aside in order to gain access to the washer reservoir filler neck.
- To install, tighten to 7 Nm (62 lb-in).
All vehicles
- Remove the bolt and the windshield washer reservoir filler neck.
- To install, tighten to 7 Nm (62 lb-in).
- Remove the windshield washer reservoir fasteners and the windshield washer reservoir.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Fill the windshield washer reservoir with windshield washer fluid.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE:
To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.
NOTE:
Do not operate the windshield washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.