Steering Wheel Bezel: Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carefully install the bezel onto the steering wheel as instructed or damage to the bezel can occur.
- Position the bezel onto the steering wheel and align the 10 pins with their respective holes.
-
NOTE: The bezel is installed in 2 stages. Stage 1 seats the 10 pins into the steering wheel approximately half-way. Stage 2 fully seats the 10 pins into the steering wheel.
Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are seated approximately half-way into the holes.
- Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are fully seated into the holes.
- Install the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM -- FUSION, MILAN & MKZ article.