Dual Climate Controlled Seat Module (DCSM): Removal
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing a new Dual Climate Controlled Seat Module (DCSM), it is necessary to carry out the Programmable Module Installation (PMI) procedure. For additional information, refer to
MODULE CONFIGURATION -- FUSION MILAN & MKZ
article.
- Before removing the DCSM, carry out the appropriate steps in the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
- Remove the front passenger seat. For additional information, refer to SEAT - FRONT in this service information.
- Remove the DCSM from the cushion electrical bracket.
- Release the locking wedges and disconnect the 3 DCSM electrical connectors.
- Remove the 2 rivets and DCSM.