Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE:
Prior to the removal of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information needs to be downloaded into the new module once installed. For additional information, refer to
MODULE CONFIGURATION -- FUSION MILAN & MKZ
article.
- Upload the module configuration information from the DSM into the scan tool. For additional information, refer to MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
- Remove the driver seat. For additional information, refer to REMOVAL AND INSTALLATION .
- Drill out the 2 rivets.
- Disconnect the 4 electrical connectors and remove the DSM.
- To install, reverse the removal procedure.
- Download the DSM configuration from the scan tool into the new DSM. For additional information, refer to MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
NOTE: If the DSM was not replaced, this substep is not necessary.
NOTE:
This step is necessary only if the Driver Seat Module (DSM) is being replaced.