LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2671 (Climate Control System) >> Removal And Installation >> In-Vehicle Temperature and Humidity Sensor - Hybrid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument cluster finish panel. For additional information, refer to INSTRUMENT PANEL & CONSOLE -- FUSION, MILAN & MKZ article.
  2. Disconnect the in-vehicle temperature and humidity sensor electrical connector.
  3. Remove the in-vehicle temperature and humidity sensor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals