LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2671 (Climate Control System) >> Removal And Installation >> Heating Ventilation Air Conditioning (HVAC) Module - Fusion, Milan >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles equipped with navigation system 

  1. Remove the Front Display Interface Module (FDIM). For additional information, refer to INFORMATION & ENTERTAINMENT SYSTEMS -- FUSION, MILAN & MKZ article.
  2. Remove the 2 HVAC module screws.
  3. Disconnect the 2 HVAC module electrical connectors and remove the HVAC module.

    Vehicles without navigation system 

  4. Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL & CONSOLE -- FUSION, MILAN & MKZ article.
  5. Remove the 4 HVAC module screws and remove the HVAC module.

    All vehicles 

  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals