LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2671 (Climate Control System) >> Removal And Installation >> Clutch and Clutch Field Coil >> Removal

Clutch and Clutch Field Coil: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A/C compressor. For additional information, refer to AIR CONDITIONING (A/C) COMPRESSOR - 2.5L  or AIR CONDITIONING (A/C) COMPRESSOR - 3.0L, 3.5L  in this service information.
  2. Remove the 3 screws and the A/C clutch shield (if equipped).
    Fig 1: Locating A/C Clutch Shield Screws
    G06262761Courtesy of FORD MOTOR CO.
  3. Remove the A/C clutch disc and hub bolt.
    1. Hold the A/C clutch disc and hub with the Compressor Clutch Disc and Hub Holding Fixture.
    2. Remove the A/C clutch disc and hub bolt.
      Fig 2: Remove/Install A/C Clutch Disc And Hub Bolt
      G06064733Courtesy of FORD MOTOR CO.
  4. Remove the A/C clutch disc and hub.
  5. Remove the A/C compressor pulley snap ring.
  6. Remove the A/C compressor pulley.
  7. Remove the A/C clutch field coil electrical connector clip screw.
    Fig 3: Locating A/C Clutch Field Coil Electrical Connector Clip Screw
    G06262763Courtesy of FORD MOTOR CO.
  8. Remove the A/C clutch field coil snap ring.
  9. Remove the A/C clutch field coil.
scientia non olet · About LEMON Manuals