LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Supplemental Inflatable Restraint System - Except F150) >> Removal & Installation >> Driver-Side Air Bag Module >> Installation

Driver-Side Air Bag Module: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air bag simulator from clockspring connector. To install, reverse removal procedure. Tighten driver-side air bag module mounting bolts to specification. See TORQUE SPECIFICATIONS .
  2. Connect negative battery cable. With air bag simulators installed at all remaining deployable devices, perform system operation check. See SYSTEM OPERATION CHECK . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals