LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Supplemental Inflatable Restraint System - Except F150) >> Disposal Procedures >> Scrapped Vehicle >> Remote Deployment Of AIR Bag

Remote Deployment Of AIR Bag

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

This procedure is to be used when a vehicle with a live driver-side or passenger-side air bag is to be scrapped.

WARNING: Air bags being deployed may cause objects to be projected away from air bag. Also, loud noise occurs during deployment. Personal injury and hearing damage may result. To ensure physical and hearing safety, perform remote deployment outdoors and keep all personnel at least 20 feet (6.09 m) away from deployment area. Wear safety goggles and hearing protection during deployment procedure.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove air bag module to be deployed. See REMOVAL & INSTALLATION . With air bag module removed, cut air bag connector from wiring harness near air bag module. Strip 1" of insulation from wire ends. Obtain 2 wires, each at least 20 gauge and 20 feet (6.09 m) or longer. Connect one end of each 20-foot wire to one end of each air bag module wire. See Fig 1 & Fig 2 .
    WARNING: Air bag module can ricochet and strike personnel if deployed. Personal injury may result. When placing a live air bag on a bench or other surface, always face air bag and trim cover up and away from surface. This will reduce motion of air bag module if it is accidentally deployed.
  3. Place air bag module, with trim cover facing upward, on a flat surface, in remote area such as parking lot or field. Remain at least 20 feet away from air bag module. Deploy air bag by touching loose ends of both wires to 12-volt battery terminals.
  4. If successful, a loud noise will be heard and bag material will be visible. Allow at least 10 minutes for cooling and dissipation of air bag effluents before approaching air bag. Air bag is now inoperative. If air bag does not deploy, air bag module is faulty. Contact vehicle manufacturer for further instructions on disposal procedures.
Fig 1: Connecting Deployment Wires To Driver-side Air Bag Module (Typical)
G99E25407Courtesy of FORD MOTOR CO.
Fig 2: Connecting Deployment Wires To Passenger-side Air Bag Module
G99D25406Courtesy of FORD MOTOR CO.