Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery. For additional information, refer to BATTERY in this service information.
- Remove the battery tray fasteners.
- Hybrid vehicles use 4 nuts.
- All other vehicles use 1 bolt and 2 nuts.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the battery tray.
- To install, reverse the removal procedure.