LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2666 (Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Knock Sensor (KS) >> Installation

Knock Sensor (KS): Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Engine block-mounted 

  1. Install the KS and the bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  2. Connect the KS electrical connector.
  3. Install the lower intake manifold. For additional information, refer to ENGINE MECHANICAL - 3.0L (4V) -- FUSION & MILAN article.

    Cylinder head-mounted 

  4. Install the KS and the bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. Connect the KS electrical connector.
scientia non olet · About LEMON Manuals