Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Steering column shroud removed to show clarity.

Remove the upper storage compartment tether nut.
- To install, tighten to 6 Nm (53 lb-in).
  
  Fig 1: Locating Upper Storage Compartment Tether Nut
  Courtesy of FORD MOTOR CO.
Remove the upper storage compartment mat and the 2 upper storage compartment screws.
Remove the upper storage compartment in the following sequence.
1. Pull the upper storage compartment toward the rear of the vehicle to release the 5 retaining clips.
2. Disconnect the electrical connector, if equipped.
To install, reverse the removal procedure.