Brake Booster Vacuum Sensor - Non-Hybrid
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery. For additional information, refer to BATTERY, MOUNTING & CABLES -- FUSION, MILAN & MKZ article.
- Remove the 2 brake fluid remote reservoir nuts and position the reservoir aside.
- To install, tighten the nuts to 7 Nm (62 lb-in).
- Disconnect the vacuum sensor electrical connector and remove the vacuum sensor.
- To install, reverse the removal procedure.