Rear Lean
WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
A side-to-side lean at the rear of the vehicle can be adjusted approximately 10 mm (3/8 inch) by installing a shim between the rear spring and the rear axle on the low side of the vehicle. A "low at the rear" vehicle can be raised approximately 10 mm (3/8 inch) by installing a shim on each side of the vehicle.