LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2659 (Hydraulic Brake System Actuation) >> Removal And Installation >> Brake Pedal Angle Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pedal bracket. For additional information, refer to BRAKE PEDAL AND BRACKET - HYBRID  in this service information.
  2. Remove and discard the 2 brake pedal angle sensor screws.
  3. Remove the brake pedal angle sensor.
  4. To install, reverse the removal procedure.
    • Install new brake pedal angle sensor screws.
  5. Carry out the Multi-Calibration Routine. Follow the scan tool directions.
scientia non olet · About LEMON Manuals