LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2658 (Parking Brake System - Parking Brake & Actuation) >> Removal And Installation >> Parking Brake Control >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL & CONSOLE -- FUSION, MILAN & MKZ article.
  2. Make sure the parking brake control is in the released position.
  3. Disconnect the warning indicator switch electrical connector.
  4. Loosen the parking brake control adjusting nut.
  5. Remove the 2 parking brake control nuts.
    • To install, tighten to 20 Nm (177 lb-in).
  6. Remove the parking brake control bolt and the parking brake control.
    • To install, tighten to 20 Nm (177 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals