LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2657 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Removal

Rear Disc Brake: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS & TIRES article.
  2. Disconnect the parking brake cable from the brake caliper.
    • Pull back the parking brake lever.
    • Disconnect the cable from the parking brake lever.
    • Remove the cable conduit retaining clip.
    • Disconnect the cable from the brake caliper.
  3. NOTE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.

    Remove the 2 brake caliper anchor plate bolts and position the brake caliper, brake pads and brake caliper anchor plate aside as an assembly.

    • Support the brake caliper, brake pads and brake caliper anchor plate assembly using mechanic's wire.
  4. Remove the 2 brake disc screws and the brake disc.
scientia non olet · About LEMON Manuals