LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2657 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Installation

Rear Disc Brake: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Make sure the brake disc-to-hub mounting surface is free of rust and foreign material before applying anti-seize lubricant.

    Install the brake disc and the 2 brake disc screws.

    • Using the specified brake cleaner, clean the mating surfaces.
    • Apply specified lubricant as shown in illustration.
    • Tighten the screws to 20 Nm (177 lb-in).
    Fig 1: Locating Brake Disc Lubricant Applying Areas
    G06269624Courtesy of FORD MOTOR CO.
  2. NOTE: Make sure that the brake caliper hose is not twisted.

    Position the brake caliper, brake pads and brake caliper anchor plate assembly and install the 2 brake caliper anchor plate bolts.

    • Tighten to 70 Nm (52 lb-ft).
  3. Install the parking brake cable to the brake caliper.
    • Pull back the parking brake lever.
    • Connect the cable to the parking brake lever.
    • Install the cable conduit retaining clip.
  4. Install the wheel and tire. For additional information, refer to WHEELS & TIRES article.
  5. Cycle the park brake several times to verify normal operation.
scientia non olet · About LEMON Manuals