LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2652 (Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Cover Seal >> Installation

Cover Seal: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the Driver Handle, the Halfshaft Oil Seal Installer and the Shaft Bearing Cup Installer as shown in the illustration.
    Fig 1: Identifying Driver Handle, Halfshaft Oil Seal Installer And Shaft Bearing Cup Installer
    G06064379Courtesy of FORD MOTOR CO.
  2. Using the Driver Handle, the Halfshaft Oil Seal Installer and the Shaft Bearing Cup Installer, install the cover seal in the PTU.
    Fig 2: Identifying Driver Handle, Halfshaft Oil Seal Installer And Shaft Bearing Cup Installer
    G06064380Courtesy of FORD MOTOR CO.
  3. Install the intermediate shaft seal deflector. For additional information, refer to INTERMEDIATE SHAFT SEAL DEFLECTOR  in this service information.
  4. Fill the PTU as necessary. For additional information, refer to POWER TRANSFER UNIT (PTU) DRAINING AND FILLING  in this service information.
scientia non olet · About LEMON Manuals