LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 265 (Rear Suspension) >> Removal And Installation >> Wheel Studs - Drum Brake >> Removal

Wheel Studs - Drum Brake: Removal

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Never use a hammer to remove the wheel stud or damage to the axle flange, wheel bearing or hub bearing can occur.
  1. Remove the brake drum. For additional information, refer to DISC & DRUM .
  2. Using the special tool, press the wheel stud from its seat and discard.
    Fig 1: Pressing Out Wheel Stud
    G00376993Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals