LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2647 (Exterior Lighting System) >> Removal And Installation >> Headlamp Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel side finish panel.
    2. NOTE: The headlamp switch bezel is removed by pushing from behind.
  2. Release the tabs and remove the headlamp switch and bezel assembly.
    • Disconnect the electrical connector.
    3. NOTE: The 3 retaining tabs on the headlamp switch are located at approximately the 3, 6 and 11 o'clock positions when viewed from the front.
  3. Release the tabs and separate the headlamp switch from the bezel.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals