LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2629 (Exhaust System) >> Removal And Installation >> Catalytic Converter - 3.0L LH Manifold >> Removal

Catalytic Converter - 3.0L LH Manifold: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the oil level indicator and tube. For additional information, refer to ENGINE MECHANICAL - 3.0L (4V) -- FUSION & MILAN article.
  3. Disconnect the Heated Oxygen Sensor (HO2S) and the Catalyst Monitor Sensor (CMS) electrical connectors.
  4. Remove the 2 LH catalytic converter-to-exhaust flexible pipe nuts.
    • Discard the gasket and the 2 nuts.
  5. Remove the 4 bolts and the LH catalytic converter manifold shield.
  6. Remove the 2 LH catalytic converter manifold shield bracket bolts and the shield bracket.
  7. Remove the 2 LH catalytic converter manifold bracket bolts and bracket.
  8. Remove the 6 nuts and the LH catalytic converter manifold.
    • Discard the 6 LH catalytic converter manifold nuts and the gasket.
  9. Remove and discard the 6 LH catalytic converter manifold studs.
  10. Clean and inspect the catalytic converter manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals