LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2628 (Engine System - General Information) >> General Procedures >> Cylinder Bore Out-of-Round

Cylinder Bore Out-of-Round

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to the appropriate article in ENGINE MECHANICAL - 2.5L (EXCEPT HYBRID) , ENGINE MECHANICAL - 2.5L - (HYBRID) , ENGINE MECHANICAL - 3.0L (4V) or ENGINE MECHANICAL - 3.5L for the specification.
  1. Measure the cylinder bore in 2 directions. The difference is the out-of-round.
    Fig 1: Identifying Cylinder Bore Out-Of-Round Measuring Directions
    G07780444Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals