Wheel Bearing, Hub, Knuckle, Upper Arm and Lower Arm - Front: Notes

WARNING: This page is about a different car, the 2004 Lincoln LS and 2003 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

MATERIAL

Item	Specification
High Temperature Nickel Anti-Seize Lubricant XL-2	ESE-M12A4-A

NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut from ball joints and stabilizer bar links.

With the vehicle in NEUTRAL, position on a hoist.

If removing an upper arm, remove the shock absorber and spring assembly. For additional information, refer to SHOCK ABSORBER AND SPRING ASSEMBLY - FRONT .

TO REMOVE INDIVIDUAL SUSPENSION COMPONENTS, ONLY CARRY OUT THE LISTED STEPS

Component	Steps
Wheel bearing and hub assembly	1-7
Wheel knuckle	1-11
Upper arm	9, 12-14
Lower Arm	15-22

Remove the parts in the order indicated in the following illustrations and tables.

Fig 1: Front Suspension (1 Of 2)
Courtesy of FORD MOTOR CO.

Fig 2: Front Suspension (2 Of 2)
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.