Item 12: Upper Arm-to-Body Nut Removal Note

WARNING: This page is about a different car, the 2004 Lincoln LS and 2003 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following steps apply to LH upper arm only.

Remove and discard the nut. Position aside the power steering reservoir.

Fig 1: Identifying Power Steering Reservoir Nut
Courtesy of FORD MOTOR CO.
Disconnect the fluid level sensor connector.

Fig 2: Identifying Brake Fluid Level Sensor Connector
Courtesy of FORD MOTOR CO.
Disconnect the brake master cylinder main pressure transducer electrical connector, if equipped.

Fig 3: Identifying Brake Master Cylinder Main Pressure Transducer Connector
Courtesy of FORD MOTOR CO.
Back out the reservoir bolt to give access to the master cylinder bolt.

Fig 4: Identifying Brake Reservoir Bolt
Courtesy of FORD MOTOR CO.
Remove the two brake master cylinder nuts and position aside the brake master cylinder.

Fig 5: Identifying Brake Master Cylinder Nuts
Courtesy of FORD MOTOR CO.