Differential Seals - LH: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
Turn the ignition to the OFF position.
Remove the 7 screws and the underbody cover.

Fig 1: Locating Underbody Cover Mounting Screws
Courtesy of FORD MOTOR CO.
Remove the drain plug and drain the transmission fluid.

Fig 2: Locating Drain Plug
Courtesy of FORD MOTOR CO.
Remove the LH halfshaft. For additional Information, refer to FRONT DRIVE HALFSHAFTS article.
Using the Slide Hammer and Input Shaft Oil Seal Remover, remove and discard the LH differential seal.

Fig 3: Removing LH Differential Seal Using Slide Hammer And Input Shaft Oil Seal Remover

Courtesy of FORD MOTOR CO.