Valve Spring, Retainer and Seal

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOL(S)

	Compressor, Valve Spring 303-300 (T87C-6565-A)
	Compressor, Valve Spring 303-350 (T89P-6565-A)
	Compressor, Valve Spring 303-1249
	Installer, Valve Stem Oil Seal 303-470 (T94P-6510-CH)

MATERIAL

Item	Specification
Motorcraft® SAE 5W-20 Premium Synthetic Blend Motor Oil (US); Motorcraft® SAE 5W-20 Super Premium Motor Oil (Canada) XO-5W20-QSP (US); CXO-5W20-LSP12 (Canada)	WSS-M2C945-A

NOTE: Lubricate the valve stem seal with clean engine oil prior to installation.

Fig 1: Installing Valve Stem Seal Using Valve Stem Oil Seal Installer

Courtesy of FORD MOTOR CO.

Using the Valve Stem Oil Seal Installer, install a new valve stem seal.
Using the Valve Spring Compressors, install the valve spring, retainer and key.

Fig 2: Remove/Install Keys, Retainer And Spring Using Valve Spring Compressors
Courtesy of FORD MOTOR CO.
Install the valve tappets. For additional information, refer to VALVE TAPPETS in this service information.