LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2616 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. If equipped, remove the 6 screws and the underbody shield.
    Fig 1: Locating Underbody Shield Screws
    G07784518Courtesy of FORD MOTOR CO.
  3. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  4. Remove the EOP switch.
    • To install, tighten to 14 Nm (124 lb-in) plus an additional 180 degrees.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals