LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2615 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
    2. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing.
  2. Remove the engine oil filter.
    • To install, tighten to 5 Nm (44 lb-in) and then rotate an additional 180 degrees.
  3. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  4. Remove the EOP switch.
    • To install, tighten to 14 Nm (124 lb-in).
  5. To install, reverse the removal procedure.
    • Apply thread sealant with PTFE to the EOP switch threads.
scientia non olet · About LEMON Manuals