LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2614 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valve stem seal installation sleeve.
    Fig 1: Identifying Valve Stem Seal
    G07780687Courtesy of FORD MOTOR CO.
  2. Using the Valve Stem Oil Seal Installer, install the valve seal.
    Fig 2: Installing Valve Seal Using Valve Stem Oil Seal Installer
    G07780688Courtesy of FORD MOTOR CO.
    3. NOTE: Check the seating of the valve collet.
    Fig 3: Remove/Install Valve Spring Using Valve Spring Compressor
    G07780689Courtesy of FORD MOTOR CO.
  3. Using the Valve Spring Compressors, install the valve spring.
    • Insert the valve spring and the valve spring retainer.
    • Compress the valve spring and install the valve collet using some grease and a small screwdriver.
  4. Disconnect the compressed air supply.
  5. Repeat the appropriate removal and installation steps for all of the other cylinders.
  6. Install the spark plugs. For additional information, refer to ENGINE IGNITION - 2.5L -- FUSION & MILAN (EXCEPT HYBRID) article.
  7. Coat the valve tappets with clean engine oil and insert them.
  8. Install the camshafts. For additional information, refer to CAMSHAFTS  in this service information.
scientia non olet · About LEMON Manuals