Brake Pedal Position (BPP) Switch
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
The BPP switch is sometimes referred to as the stoplamp switch. The BPP switch provides a signal to the PCM indicating the brakes are applied. The BPP switch is normally open and mounted on the brake pedal support. Depending on the vehicle application the BPP switch can be hardwired as follows:
- to the PCM supplying battery positive (B+) voltage when the brake pedal is applied.
- to the anti-lock brake system (ABS) module, or lighting control module (LCM), the BPP signal is then broadcast over the network to be received by the PCM.
- to the ABS traction control/stability assist module. The ABS module interprets the BPP switch input along with other ABS inputs and generates an output called the driver brake application (DBA) signal. The DBA signal is then sent to the PCM and to other BPP signal users.