DTC P1A08: Generator Mode Signal
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
P1A08 - GENERATOR MODE SIGNAL
| Description: | The transaxle control module (TCM) continuously monitors the controller area network (CAN) communication bus for a generator mode message from the powertrain control module (PCM). This DTC sets when the received message does not match the actual generator mode. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the GENMODE parameter identification (PID). The PID state ERROR indicates a hardware concern. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST TI . | ||