DTC P0452: Evaporative Emission System Pressure Sensor/Switch Low
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
P0452 - EVAPORATIVE EMISSION SYSTEM PRESSURE SENSOR/SWITCH LOW
| Description: | The powertrain control module (PCM) monitors the evaporative emission (EVAP) control system fuel tank pressure (FTP) sensor input signal to the PCM. The test fails when the signal average drops below a minimum allowable calibrated parameter. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | An FTP voltage parameter identification (PID) reading less than 0.22 volt with the ignition on, engine off or ignition on, engine running, indicates a concern is present. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST HX . | ||