LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2604 (Engine Controls - Diagnostic Methods (Hybrid)) >> Intermittent Diagnostic Techniques >> Accumulating PCM Data

Accumulating PCM Data

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

PCM data can be accumulated in a number of ways. This includes circuit measurements with a digital multimeter (DMM) or scan tool parameter identification (PID) data. Acquisition of PCM PID data using a scan tool is one of the easiest ways to gather information. Gather as much data as possible when the fault is occurring to prevent incorrect diagnosis. Gather data during different operating conditions and based on the customer description of the intermittent fault. Compare this data with the known good data values located in TYPICAL DIAGNOSTIC REFERENCE VALUES . This requires recording data in four conditions for comparison: 1) KOEO, 2) Hot Idle, 3) 48 km/h (30 mph), and 4) 89 km/h (55 mph).

scientia non olet · About LEMON Manuals