Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

While pushing in on the 2 glove compartment door tabs, position the glove compartment downward.
Remove the Vehicle Dynamics Module (VDM) in the following sequence.
1. Disconnect the 2 electrical connectors.
2. Remove the 2 bolts and the VDM.
  - To install, tighten to 3 Nm (27 lb-in).
To install, reverse the removal procedure.