LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2557 (Information System And Entertainment System) >> Removal & Installation >> Antenna Lead-In Cable - Front >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the audio unit. For additional information, refer to Audio Unit .
  2. Remove the RH lower A-pillar trim panel.
  3. Fig 1: Locating RH Lower A-Pillar Trim Panel
    GF0019052Courtesy of FORD MOTOR CO.
  4. Position the RH lower instrument panel cover aside.
    1. Remove the pin-type retainers.
    2. Position the lower instrument panel cover aside.
  5. Fig 2: Identifying Pin-Type Retainers And Lower Instrument Panel Cover
    GF0019053Courtesy of FORD MOTOR CO.
  6. Disconnect the RH lower instrument panel cover light and remove the RH lower instrument panel cover.
  7. Fig 3: Locating RH Lower Instrument Panel Cover Light
    GF0019054Courtesy of FORD MOTOR CO.
  8. Disconnect the antenna lead-in cable.
  9. Fig 4: Locating Antenna Lead-In Cable
    GF0019055Courtesy of FORD MOTOR CO.
  10. Remove the antenna lead-in cable.
    1. Remove the 5 clips.
    2. Remove the antenna lead-in cable.
  11. Fig 5: Identifying Antenna Lead-In Cable Clips
    GF0019056Courtesy of FORD MOTOR CO.
  12. To install, reverse the removal procedure.