LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2551 (Accessory Drive System) >> Diagnostic Tests >> Accessory Drive >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Chart

Condition Possible Sources Action
  • Accessory drive belt cracking (over 15 cracks in a rib over a distance of 100 mm [4.0 in])
  • Accessory drive belt
  • Accessory drive belt chunking
  • Accessory drive belt
 
  • Damaged pulley grooves
  • INSPECT the accessory drive belt pulley grooves for damage. INSTALL a new pulley or component as necessary.
  • Accessory drive belt noise, squeal, chirping or flutter
  • Defective/worn or incorrect accessory drive belt
  • Misaligned pulley(s)
  • Pulley runout
  • Damaged or worn accessory drive component or idler
  • Fluid contamination of accessory drive belt or pulleys
  • REFER to Drive Belt - Noise/Flutter in Component Tests . REPAIR or INSTALL new parts as necessary.
 
  • Damaged or worn accessory drive belt tensioner
  • REFER to Drive Belt - Noise/Flutter in Component Tests . INSTALL a new accessory drive belt tensioner as necessary.
 
  • Damaged pulley grooves
  • INSPECT the accessory drive belt pulley grooves for damage. INSTALL a new pulley or component as necessary.
 
  • Accessory drive component failure
  • CHECK the accessory drive components. INSTALL new components as necessary.
 
  • Accessory drive belt idler pulley bearing failure
  • INSPECT the accessory drive belt idler pulley for freedom of rotation and damage. INSTALL a new accessory drive belt idler pulley as necessary.
  • Premature accessory drive belt wear
  • Defective or incorrect accessory drive belt
  • Misaligned pulley(s)
  • Pulley runout
  • Damaged accessories
  • Incorrectly installed drive belt
  • Fluid contamination
  • REFER to Drive Belt - Noise/Flutter in Component Tests . REPAIR or INSTALL new parts as necessary.
 
  • Damaged pulley grooves
  • INSPECT the accessory drive belt pulley grooves for damage. INSTALL a new pulley or component as necessary.