LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2550 (Engine Mechanical - 4.6L (2V)) >> In-Vehicle Servicing >> Valve Springs >> Removal

Valve Springs: Removal

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the camshaft roller followers. For additional information, refer to Camshaft Roller Follower .
  3. Remove the spark plugs. For additional information, refer to ENGINE IGNITION - 4.6L (2V) article.
  4. Position the piston at the top of the stroke.
  5. Install compressed air in the cylinder to hold both valves in position.
    6. NOTE: If air pressure has forced the piston to the bottom of the cylinder, any loss of air pressure will allow the valve to fall into the cylinder. If air pressure must be removed, support the valve prior to removal.
  6. Use the Valve Spring Compressor to compress the valve springs.
    7. Fig 1: Compressing Valve Spring
    GF0046684Courtesy of FORD MOTOR CO.
  7. Remove the valve spring retainer keys, the valve spring retainers and the valve spring.
scientia non olet · About LEMON Manuals