LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2550 (Engine Mechanical - 4.6L (2V)) >> In-Vehicle Servicing >> Engine Oil Pressure (EOP) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector and remove the EOP switch.
    • To install, tighten to 14 Nm (124 lb-in), then tighten an additional 180 degrees.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals